Boilers
This is the current list of supported boilers from brands like Buderus, Nefit, Sieger, Junkers and Bosch:
- BK13, BK15
- GB125, GB135, GB1x2i, GB162, GBx72, GB212, GB162, GB192, GB122, GB192i.2
- MC10
- Cascade CM10, MC400
- Logano
- Logamax Plus GB022, U122
- Logamatic MC10, MC110
- Condens 2500, GC9000
- Bosch/Junkers Cerapur GC2200W
- Logomatic
- Bosch/Junkers Cerapur Top, Aero
- Bosch/Junkers Cerapur ZSB 14-3 A
- Greenstar Si, 30Ri Compact, ErP, HIU, 8000
- Nefit Topline, Trendline
- Cascade MCM10
- Nefit Proline
- Nefit Smartline
- GC7000F, GC700iW, GC9800IW
- KB195i
- Hybrid Heatpump
- Enviline
- Compress 6000AW
- Hybrid 3000-7000iAW
- SupraEco
- WLW196i, WSW196i
- Condens 2300, 5000i
- Ecomline Excellent
- EasyControl Adapter
Device Entities with Commands
info
The boiler commands below will vary depending on boiler type/brand and system configuration Some commands will not work because they are overwritten by controller or thermostat. In this case there are thermostat commands for this setting.
:::warning this list is not complete and subject to change between versions. :::
command | data | id | comments |
|---|---|---|---|
comfort | <hot |eco | intelligent> | ||
flowtemp | <degrees> | Limited to heatingtemp, set by thermostat if present | |
dhw.settemp | <degrees> | Only if thermostat does not manage it | |
boilhyston | <degrees> | Start burner below flowtemp (negative value), allowed range depends on boiler type | |
boilhystoff | <degrees> | Stop burner above flowtemp (positive value), allowed range depends on boiler type | |
burnperiod | <minutes> | ||
burnminpower | <%> | Changeable only for modulated burners | |
burnmaxpower | <%> | Changeable only for modulated burners | |
pumpdelay | <minutes> | ||
dhw.activated | <off | on> | ||
dhw.tapactivated | <off | on> | Special function working in boiler test-mode | |
dhw.onetime | <off | on> | Overwritten by some thermostats, see thermostat commands | |
dhw.circpump | <off | on> | ||
dhw.circ | <off | on> | Overwritten by some thermostats, see thermostat commands | |
dhw.circmode | <n> | (1=1x3min, .. 6=6x3min, 7=on) | |
dhw.flowtempoffset | <degrees> | Offset to boiler temperature while preparing warm water | |
dhw.maxpower | <%> | Maximum power for warm water heating | |
heatingactivated | <off | on> | Not changeable for some systems. i.g. Set by MC10 rotary control | |
heatingtemp | <degrees> | Upper limit for flowtemp, not changeable for some systems or overwritten (MC10) | |
maintenance | <off | <hours> | <dd.mm.yyyy> | reset> | set maintenance to date or time or reset message | |
pumpmodmin | <%> | Changeable only for modulated pumps | |
pumpmodmax | <%> | Changeable only for modulated pumps | |
reset | <error | maintenance> | Use reset error only if there is an active error! |